101 results in 0.0082 seconds.
reseat
-
I work with two theaters here in Rochester in our chain that use 20 SR-1000s across the two buildings. Steve - you mention that you use the enterprise... -
You are starting to get into the CAT772 board (I/O board). The CAT790 handles the AES input AND the surround outputs. That would explain working surrounds...Leave a comment:
-
Might be time to recap the power supply in that CP650. Power supply issues can cause all sorts of strange things to happen. I'd also run the CP 650 on...Leave a comment:
-
Video editing is a niche use case: relatively few personal computer owners will ever want to do it, but those who do will need processing power, RAM,...Leave a comment:
-
Power the unit down, open the front panel.
Pull and reseat the main boards on the bottom, and do the same for all of the cards in the card...Leave a comment:
-
NEC NC900 failure
Hi, a colleague just called me about his NC900 issue that came up today. Until yesterday, everything was working okay with his Doremi DCP2K4 and NC900....Last edited by Carsten Kurz; 12-14-2024, 07:06 AM. -
So ...
There is no internet available on that location. There used to be a public WIFI for some years, but that was always unstable, and...Last edited by Carsten Kurz; 12-16-2024, 07:16 AM.Leave a comment:
-
By far, the ICP module, which has a lot of very low-current contacts (both sides) is the primary culprit. Some projectors have fared better than others....Leave a comment:
-
Out of curiosity, I just ran this search: https://www.film-tech.com/vbb/search?q=reseat . I get 93 posts with the word "reseat." Are the board...Leave a comment:
-
That is on the WAN side of things so the CPU (NEC's CCB) board might be able to talk to the outside but not to any of the LAN devices. I'd still start...Leave a comment:
-
It's a Christie! They all are starting to point to the PIB/signal backplane board on a typical Christie or its related wiring. There is also the off-chance...Leave a comment:
-
Barco ICMP image slowed playback
I have very strange problem with barco 10s projector and ICMP (2nd generation). While playind dcp, no mater is it trailler, feature etc picture is kinda... -
Huh? Did someone mention me?
First off...the IMB/IMS or Enigma (SDI based system) is the security manager for the projector. You will...Leave a comment:
-
Did you reseat any cables while you had the light engine compartment open? If so, that likely explains the DMD sensor error.
It should be...Leave a comment:
-
It should not fail. Under normal circumstances, once the marriage procedure has been done, it should not be broken unless a tamper detection switch is...Leave a comment:
Leave a comment: