DB15 Cable pin config

[Avinash Kamath]

Dear all
Actually I miss my GET D G880 3d unit DB15 Cable. So I want pin config of DB15 to DB 15 , any one you have the pinout of DB15 please share me . below is we are using our cinema equipment.

Projector - Barco sp4k
3d Unit - Get D GK880

[Leo Enticknap]

I hadn't heard of GetD before - it appears to be an Indian 3-D system:

image.png

Only problem is that when I clicked on any of the realfilms.co.in links, I got "page not found."

A bigger problem could be that the Barco Series 4 doesn't seem to support GetD out of the box:

image.png
So you'll need to create a 3-D configuration file based on their published specs, as well as buy or make a DB15 cable. If GetD doesn't sell a pre-made cable, you'll have to make one up yourself. If you don't want to solder, there are plenty of DB15 to Phoenix-type connectors available: I use them for hooking up Q-Sys fire alarm GPIs all the time. The pinouts at the Barco end should be in the SP4K's service manual (I don't have it easily to hand, or else I'd try to snip them for you), and at the GetD end, they should hopefully be in the documentation that shipped with the 3-D system.

[Marin Zorica]

Settings are much like realD, i think that G880 is something like readDXL? I've had few of those unit, and for cable i got it with bnc at end. So just cut it and solder to db15 for barco. And in barco manual you cca find connectors pinout somewhere on last pages of installation manual.

[Jerry Bian]

I hadn't heard of GetD before - it appears to be an Indian 3-D system:

image.png

Only problem is that when I clicked on any of the realfilms.co.in links, I got "page not found."

A bigger problem could be that the Barco Series 4 doesn't seem to support GetD out of the box:

image.png
So you'll need to create a 3-D configuration file based on their published specs, as well as buy or make a DB15 cable. If GetD doesn't sell a pre-made cable, you'll have to make one up yourself. If you don't want to solder, there are plenty of DB15 to Phoenix-type connectors available: I use them for hooking up Q-Sys fire alarm GPIs all the time. The pinouts at the Barco end should be in the SP4K's service manual (I don't have it easily to hand, or else I'd try to snip them for you), and at the GetD end, they should hopefully be in the documentation that shipped with the 3-D system.

hi LEO This is a Chinese brand