Film-Tech Cinema Systems

Irvine, California

Closer look at the Dubber Interface and Dolby CAT 363 frames. On the interface, the blue LED is power, the next two are red/green LEDís connected to the encoder busses and change state when the projector is running. When idle, they can be red, green, or dark. The DB15 connector allows interface to digital dubbers or hard drives for dailies work, and also carries the changeover signal. The display on the right shows the speed of the active projector. Since I programmed it wrong it reads "240" at 24 fps ... oops. But that allows accurate reading to the tenth of a frame, so maybe Iíll leave it alone.

August 2010 photo from the Tony Bandiera Jr collection.

© 1999-2020 Film-Tech Cinema Systems, LLC. All rights reserved. :: 1.69 :: 2.11