 1.  Copy install.exe into a directory on your harddrive.

 2.  Run the intall.exe program inside the new directory.

 3.  Run the setup.exe program that has been extracted and choose
    the correct com port (1 or 2).

 4.  If you are running under windows(95-98), you must restart in
    DOS mode.

 5. If you are in DOS mode then run comscrn.exe . You need the
   master remote box to be on in the system in order to get the full display
   to work. Without the master remote box on, you will only see the TA-10
   codes as they change condition ( i.e. start, stop, fail).
